Trapezoid double round grinding shoes are the go-to choice when you need a balance between aggressive material removal and a smooth, scratch-minimized finish. Because they have a rounded edge, they lack the sharp “leading edge” of a rectangular or arrow-shaped segment, which helps prevent deep gouging on uneven concrete.
Huanlong single row diamond grinding cup wheel, For fast and aggresive grinding hard material such as concrete, Terrazzo, Engineered Stone, granit, marble and etc.
Klindex Diamond Grinding Disc/Ring, designed specifically for concrete floor grinders. It is mainly used for grinding, polishing and renovating various hard surfaces such as concrete, terrazzo, marble and natural stone.
Werkmaster single round grinding shoes are specialized diamond abrasive tools designed for aggressive concrete grinding, surface preparation, and initial polishing steps using the Plug N Go system. These metal-bond shoes are available in various bonds (soft, medium, hard) to suit different concrete hardness levels.
Fast removal of thick coating such as old glue, epoxy, paint, in particular thick resins.
Creates slip-resistant finish on granite and marble, breaks down coatings prepares surface for application of new coating overlay, enhances the combination of floor and new layer material.
Email：
contact@hldiamondtools.com
This 8″ bush hammer tool can be used with floor machines or powerful grinders for bush hammering of concrete floors and surfaces. They have 4 rollers with 1″ center bore size for appropriate floor grinding machines.
Adjustment of grit for bush-hammered surface
The Roughness of the bush hammered surface can be adjusted with our bush hammer through adjustment of spring elasticity on the bush hammer, or through the pressure of the manual grinding machine. Loosening spring elasticity or lessening pressure with increased roughness of hammering will result and tightening the springs or increasing machine pressure will reduce roughness to give the bush hammered surface a finer look.
Use and maintenance of bush hammer
Operating Speed: 700-800 RPM
Wet use strongly recommended and the more water the better
Do not apply too much pressure on bush hammer. This will prevent roller from stopping and thus decrease the life span of the tungsten steel
After each use, please clean up rollers, dry and apply oil to the spindles. It will be ideal to submerge the rollers in oil to prevent spindle rust
Roller tips can be re-dressed with diamond blades when they become inefficient.
Note：Please leave your email, our professional person will contact you asap!
Keywords: CW505、CW507、Class B water mill、7-inch turbine 30
