Redi lock type bush hammer heads for Husqvarna floor grinders.
Used for making non-slip surface on the floor or removing coatings.
Dust-proof design of the roller lengthens its lifespan.
The unique layout of carbides results in a specific finish.
PRODUCTS
HOT PRODUCTS
“For easy installation of velcro back resin floor polishing pad onto floor grinding machine. Eg: REDILOCK, LAVINA, HTC, SKINMAKIN, SWITCH, STI, etc. “
The PCD system quick replacement tool is suitable for epoxy resin, coatings, adhesives, sealants, and coatings. It cannot be used directly on concrete and any metal materials.
The grinding wheel is characterised by a flawless quality at a very high diamond concentration. It allows for quick and cool sanding with a clean sanding pattern. The disc is particularly used on industrial floors, preparation of concrete floors and in the preparation of new coatings, for the removal of old coatings or coverings.
HTC single bar grinding shoes Segment Size 40*10*12mm, EZ change grinding disc for HTC grinding machine.
HTC single bar grinding shoes are more aggressive compared to their double-segment plate. Because the machine’s entire weight is concentrated on half the surface area (one bar instead of two), they bite significantly deeper into the concrete and best for lighter machines.
Email：
contact@hldiamondtools.com
HTC Grinding shoes concrete terrazzo floor pads – with Single bar segment HTC Diamond Grinding Tools with 1pc rectangle segment
1. When to Use Single Bar Shoes
• Hard Concrete: If you are struggling to “open up” a very hard, high-PSI concrete floor, single bars provide the downward pressure needed to keep the diamonds from glazing over.
• Lightweight Grinders: On smaller or single-phase machines that lack the head weight of a large industrial grinder, single bars ensure the tool actually engages with the surface rather than just skating over it.
• Thin Coating Removal: They are excellent for “scarifying” or removing thin layers of paint, glue, or epoxy because they “plow” through the material more effectively than a flat double-bar.
• Exposing Aggregate: If the goal is a “salt and pepper” or large aggregate look, the single bar will cut through the cream layer much faster.
2. Choosing the Right Bond
To get the most out of your HTC tooling, you must match the metal bond to the hardness of your concrete (measured by a Mohs scratch test):
• Soft Bond: Use on Hard concrete. The bond wears away quickly to reveal fresh diamonds.
• Medium Bond: Use on Medium hardness concrete.
• Hard Bond: Use on Soft/Abrasive concrete. A hard bond prevents the abrasive concrete from eating through your segment too quickly.
Note：Please leave your email, our professional person will contact you asap!
