Fast removal of thick coating such as old glue, epoxy, paint, in particular thick resins.
Creates slip-resistant finish on granite and marble, breaks down coatings prepares surface for application of new coating overlay, enhances the combination of floor and new layer material.
The M16 thread 180mm Hybrid PCD diamond grinding cup wheel is designed for fast removing hard and tacky surface coating including urethane epoxy, paint, glue, ,waterproofing membrane,pool deck coating, thick mastic,VCT mastic, black tar adhesive, old and new epoxy coating, as well as thick rubber materials on the concrete floor.
“Feasures: 1) Application: These triangle shaped grinding cup wheel are great for any type of concrete construction work. They can also be used for aggressive stone removal, such as concrete, hard granite, marble, engineered stone, terrazzo etc 2) 22.23mm arbor; Flange with thread M14 or 5/8″”-11available 3) Coarse, medium and fine grit on request 4) Aggressive grinding with long lifetime 5) Application:Concrete,granite,marble stones”
Huanlong 2 Parallel segments Lavina grinding shoesare specifically designed for high-efficiency floor prep and aggressive coating removal.
Polar PCD grinding disc The PCD block trapezoidal plate is designed for removing thin layers of iron chips and release agents. The embedded PCD slices are distributed across various segments, resulting in very rough scratches. This plate is highly effective when aggressive grinding is required.
Email：
contact@hldiamondtools.com
Why Do We Use Tungsten Bits to Replace Diamond Bars on PCD Grinding Shoes?
But we tend to use tungsten bits to replace those diamond bars based on the following reasons:
1.Tungsten carbide are highly durable and can withstand significant wear and tear. They are less likely to chip or break when compared to diamond segments, and may consume at same speed with those PCD bits, which can better balance the PCD grinding shoes till to the end.
2.Tungsten carbide bits can be used in a wider range of materials and applications, including metal, wood, plastics, rubber. Diamonds are primarily suited for cutting hard and bristle materials. Tungsten carbide bits will be more suitable for removing those adhesives.
3.Tungsten carbide has good heat resistance properties allowing it to maintain its hardness and cutting ability at high temperatures. Diamond may degrade or even burn at high temperatures. Tungsten carbide bits will be suitable underthe tough working conditions for removing those adhesives.
Note：Please leave your email, our professional person will contact you asap!
Keywords: CW505、CW507、Class B water mill、7-inch turbine 30
