Plustic Backing Pad M14 For Diamond Polishing Pad, Wet or Dry use
PRODUCTS
HOT PRODUCTS
“PCD Plug WITH 3 PCDs are designed to remove coating over a surface equal to a troweled surface and will not damage the concrete. One of the 3 PCDs act as a stabilizer and depth guide, and reduce the gauging of the floor caused by the aggressive pcd segments. Diamond plug for Floorex grinder, with different shapes segments. But what is more important, especially in the initial grinding steps, is the bond or hardness of the tools. “
Huanlong Double row diamond grinding cup wheel, For fast and aggresive grinding hard material such as concrete, Terrazzo, Engineered Stone, granit, marble and etc.
Fast removal of thick coating such as old glue, epoxy, paint, in particular thick resins.
Creates slip-resistant finish on granite and marble, breaks down coatings prepares surface for application of new coating overlay, enhances the combination of floor and new layer material.
Husqvarna 2×1/4 PCD + Bar Trapezoid Diamond Grinding Shoes long lifespan Coating Removal Tools
Double Quarter Round PCD With 1 Segment Best Use For Epoxies, acrylics, paints, and thicker glues/mastics. Ideal for 1mm to 2mm thick coatings. Works well on both small single-head (PG 280) and medium planetary (PG 450/530) machines.
Email：
contact@hldiamondtools.com
The Redi-Lock with 2×1/4 PCD & 1 Bar Segment is the go-to tool for removing medium-thick coatings where you want to balance speed with a controlled finish.
Compare to the 3X1/4 PCD, this 2-PCD version is slightly more aggressive because the machine’s weight is concentrated on two points instead of three.
1. Why Choose 2 PCDs instead of 3?
Higher Point Pressure: With only two 1/4 chips, each chip bites deeper into the coating. This makes it better than the 3-PCD version for slightly thicker or tougher materials that a 3-PCD might “skate” over.
Faster Cutting: It removes material slightly faster in most conditions because the chips are less likely to get “clogged” with debris, as there is more open space on the tool face.
2. The Stabilizing Bar (The “Wear Bar”)
Just like the other configurations, the 1 Bar Segment is essential here:
The Depth Gauge: It limits how deep the two PCD chips can dive. Without this bar, the 2×1/4 PCDs would likely “trench” the floor or chatter violently.
The Scratch Pattern: The bar is usually a coarse metal-bond diamond (around 20-30 grit). It grinds the floor while the PCDs scrape, which helps “clean up” the aggressive gouges and prepares the concrete for the next step of metal bonds.
Note：Please leave your email, our professional person will contact you asap!
