The 180mm Crossover PCD crossover diamond grinding cup wheel is designed for super fast removing hard and tacky surface coating including urethane epoxy, paint, glue, pool deck coating, waterproofing membrane, thick mastic,VCT mastic, black tar adhesive, old and new epoxy coating, as well as thick rubber materials on the concrete floor.
Polar Magnetic Fittiing Diamond Trapezoid Single Button Segment Grinding Disc are less aggressive and leave a more subtle scratch pattern, using round segments often makes for an easier transition into resin polishing pads.
Fast Change Diamond Grinding block are high-performance tools designed for the Fast Change system. By using 4 segments instead of one or two large ones, these shoes increase the number of segments, which allows for a more aggressive and stable cut while maintaining a smooth finish.
Huanlong 5 stpes Wet diamond polishing pad for fast Wet polishing materials such as Granite, marble, Terrazzo, concrete, Engineered Stone, Porcelain, Quartz.
Maximum 4000RPM
Double Quarter Round PCD With 1 Segment Best Use For Epoxies, acrylics, paints, and thicker glues/mastics. Ideal for 1mm to 2mm thick coatings. Works well on both small single-head (PG 280) and medium planetary (PG 450/530) machines.
Email：
contact@hldiamondtools.com
The Redi-Lock with 2×1/4 PCD & 1 Bar Segment is the go-to tool for removing medium-thick coatings where you want to balance speed with a controlled finish.
Compare to the 3X1/4 PCD, this 2-PCD version is slightly more aggressive because the machine’s weight is concentrated on two points instead of three.
This Redilock PCD Shoes With only two 1/4 chips, each chip bites deeper into the coating. This makes it better than the 3-PCD version for slightly thicker or tougher materials that a 3-PCD might “skate” over. It removes material slightly faster in most conditions because the chips are less likely to get “clogged” with debris, as there is more open space on the tool face.
The Stabilizing Bar limits how deep the two PCD chips can dive. Without this bar, the 2×1/4 PCDs would likely “trench” the floor or chatter violently.
The bar is usually a coarse metal-bond diamond (around 20-30 grit). It grinds the floor while the PCDs scrape, which helps “clean up” the aggressive gouges and prepares the concrete for the next step of metal bonds.
Note：Please leave your email, our professional person will contact you asap!
Keywords: CW505、CW507、Class B water mill、7-inch turbine 30
