Fast removal of thick coating such as old glue, epoxy, paint, in particular thick resins.
Creates slip-resistant finish on granite and marble, breaks down coatings prepares surface for application of new coating overlay, enhances the combination of floor and new layer material.
SASE PCD with 5×1/4 segments is a specialized concrete grinding tool designed for aggressive coating removal. It features five “quarter-round” Polycrystalline Diamond (PCD) chunks mounted on a plate, typically using the SASE Quick Change (QC) attachment system.
Fast removal of thick coating such as old glue, epoxy, paint, in particular thick resins.
Creates slip-resistant finish on granite and marble, breaks down coatings prepares surface for application of new coating overlay, enhances the combination of floor and new layer material.
Huanlong light weight PCD diamond grinding cup wheel is Lighter than traditional diamond cup wheel for easier hand-hold grinding process. It is perfect for fast removing hard and tacky surface coating including urethane epoxy, paint, glue, ,waterproofing membrane,pool deck coating, thick mastic, old and new epoxy coating,VCT mastic, black tar adhesive as well as thick rubber materials on the concrete floor.
Double Quarter Round PCD With 1 Segment Best Use For Epoxies, acrylics, paints, and thicker glues/mastics. Ideal for 1mm to 2mm thick coatings. Works well on both small single-head (PG 280) and medium planetary (PG 450/530) machines.
Email：
contact@hldiamondtools.com
The Redi-Lock with 2×1/4 PCD & 1 Bar Segment is the go-to tool for removing medium-thick coatings where you want to balance speed with a controlled finish.
Compare to the 3X1/4 PCD, this 2-PCD version is slightly more aggressive because the machine’s weight is concentrated on two points instead of three.
This Redilock PCD Shoes With only two 1/4 chips, each chip bites deeper into the coating. This makes it better than the 3-PCD version for slightly thicker or tougher materials that a 3-PCD might “skate” over. It removes material slightly faster in most conditions because the chips are less likely to get “clogged” with debris, as there is more open space on the tool face.
The Stabilizing Bar limits how deep the two PCD chips can dive. Without this bar, the 2×1/4 PCDs would likely “trench” the floor or chatter violently.
The bar is usually a coarse metal-bond diamond (around 20-30 grit). It grinds the floor while the PCDs scrape, which helps “clean up” the aggressive gouges and prepares the concrete for the next step of metal bonds.
Note：Please leave your email, our professional person will contact you asap!
Keywords: CW505、CW507、Class B water mill、7-inch turbine 30
